Mettler Toledo XP2004S Instructions d'exploitation télécharger pdf (Page 8)

Setting up the balance

2 Setting up the balance

This Section describes how to unpack your new balance, set it up and prepare it for operation. On completion of the steps described

in this Section, your balance is ready for operation.

Note: The balance must be disconnected from the power supply when carrying out all setup and mounting

work, as well as when the housing of the weighing terminal is opened during everyday operation.

2.1 Unpacking and checking the standard equipment

Open the packaging and carefully remove all components.

2.1.1 Unpacking the draft shield

– Place the draft shield on a clean surface.

– Turn so the cover (A) is vertically on top.

– Lift the carton (B) off over the handle and the pull the carton off

toward the back.

Note: Hold the glass panels firmly so they do not get

pulled off and fall to the floor!

– Close the cover (A) again.

– Push all the glass panels as far as they will go to the back.

– Insert the bottom plate (C).

Note: For installation of the draft shield on the XP10003S

comparator balance, separate installation instructions

are enclosed.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 45 46

Pas de commentaire

Mettler Toledo XP2004S Instructions d'exploitation Page 8