Mettler Toledo LJ16 Manuel d'utilisateur télécharger pdf (Page 26)

7 Malfunctions

7.1 Interpreting the error messages

Malfunction/Message Possible cause Rectification

Printout unreadable • Ribbon worn/entangled • Change/tension ribbon

• Service life of printing unit at an end • Replace printing unit

Green pilot lamp does not light up • No power, fuse defective • Switch on power switch, have fuse replaced by

METTLER TOLEDO

Green pilot lamp flashes slowly • Balance waiting for stability/

cable not attached

Green

pilot lamp flashes rapidly • Transmission error

• Connection cable not attached or • Check handshake, initiate print command

older balance (unidir. interface) with PRINT key of balance

•

Interface parameters of LC-P45 • Set interface parameters

and balance do not match

• Calibration has been aborted • Repeat calibration

------- ABORT --------

---- Interruption ----

- Transmission error -

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Pas de commentaire

Mettler Toledo LJ16 Manuel d'utilisateur Page 26