21
6. What if ...?
Possible cause
• Spacer bolt too short
• Draft shield not mounted correctly
• Compensation weight not installed in draft
shield
• Spacer bolt too long
• Draft shield not mounted properly
•Weighing range exceeded
• Spacer bolt too long
• Power outage
• Instrument not switched on
• No power supply voltage
• Power cable not plugged in
• Voltage selector not set properly
• Microfuse blown
• Balance switched off
• Connection cable from balance to dryer
loose or not plugged in
• The configuration has been changed
Rectification
• Lengthen spacer bolt
•Mount draft shield correctly
• Install compensation weight
• Shorten spacer bolt
•Mount draft shield correctly
• Remove sample
• shorten
• Repeat drying operation. The parameter
entries are not lost through a power out-
age.
• Switch on dryer
• Check power supply
• Plug in power cable
• Set voltage selector correctly
• Check functioning of the microfuses and
replace fuses if need be
• Switch on balance
• Plug in connection cable properly
• Reenter operating parameters
Error/Display
After switching on, only the bottom segments
of the display light up
Unstable value in the display
After addition of the sample, only the top
segments of the display light up
Display “OFF”
No LED light up on the dryer
Only the LED START flashes
After switching on, the configuration is wrong
Commentaires sur ces manuels